Click to return to Home Page
  

rotary engravable >>
ADA Alternative
ColorCast Acrylics
ColorHues
NEW ColorHues™ EFX
FlexiBrass & FlexiColor
Fusion Grafix
General Purpose/Utility-Grade Sheet
Heavy Weights
Lacquers
LaserGlow
LaserLIGHTS
LaserMark
LaserMax
Lucent
Mattes
Message Board
Metalgraph plus
NoMark Plus
NEW Reflexions
Reverse LaserMark
Safe-T-Mark
Satins
Slickers
Standard Metals
Textures
The Naturals
UltraGrave
Ultra-Mattes Front-Engravable
Ultra-Mattes Reverse-Engravable

 


 
 Physical Properties
Typical Values ASTM Method
IZOD Impact Strength
Notched at 73°F (22.78°C) 1.10 ft lbs/in D-256
Tensile Strength
To break 5,500 psi D-638
Elongation before break 50% D-638
Flexural Strength
Load to stretch outer surface 5% 10,300 psi D-790
Specific Gravity 1.15 D-792
Rockwell Hardness M45 D-785
Deflection Temperature
Temperature at which material deflects .010" (.254mm) at 264 psi 175oF (79.44oC) D-648
Coefficient of Thermal Expansion
Inch/inch/°F 5.6 x 10-5 D-696
Vicat Softening Point
Temperature for needle to penetrate 1mm (90°F/hr, 2.2 lbs) 208°F (97.78°C) D-1525
Temperature for needle to penetrate 1mm (90°F/hr, 11.0 lbs) 187°F (86.11°C) D-1525
ULTRA-MATTES (REVERSE) engraving material softens at about 200°F (93.33°C) sufficiently so that it can be bent as needed. It can be sawed, drilled and bonded, but not sheared. For best appearance, sawed edges should be buffed on material 1/8" (3.0mm) and thicker.
The base and cap materials, as well as the foils, were tested for flammability by Underwriters Laboratories. The base and cap materials are rated 94 HB on the UL 94 test. The foil was judged as not contributing to the combustion of the base material.
 
NOTE: The above information is given in good faith, but no warranty, express or implied, is given.