Click to return to Home Page
  

rotary engravable >>
ADA Alternative
ColorCast Acrylics
ColorHues
NEW ColorHues™ EFX
FlexiBrass & FlexiColor
Fusion Grafix
General Purpose/Utility-Grade Sheet
Heavy Weights
Lacquers
LaserGlow
LaserLIGHTS
LaserMark
LaserMax
Lucent
Mattes
Message Board
Metalgraph plus
NoMark Plus
NEW Reflexions
Reverse LaserMark
Safe-T-Mark
Satins
Slickers
Standard Metals
Textures
The Naturals
UltraGrave
Ultra-Mattes Front-Engravable
Ultra-Mattes Reverse-Engravable

 


 
 Physical Properties
Typical Values ASTM Method
IZOD Impact Strength
Notched at 73°F (22.78°C) 1.10 ft lbs/in D-256
Tensile Strength
To break 5,500 psi D-638
Elongation before break 50% D-638
Flexural Strength
Load to stretch outer surface 5% 10,300 psi D-790
Specific Gravity 1.15 D-792
Rockwell Hardness M45 D-785
Deflection Temperature
Temperature at which material deflects .010" (.254mm) at 264 psi 175oF (79.44oC) D-648
Coefficient of Thermal Expansion
Inch/inch/°F 5.6 x 10-5 D-696
Vicat Softening Point
Temperature for needle to penetrate 1mm (90°F/hr, 2.2 lbs) 208°F (97.78°C) D-1525
Temperature for needle to penetrate 1mm (90°F/hr, 11.0 lbs) 187°F (86.11°C) D-1525
ULTRA-MATTES (FRONT) engraving material softens at about 200°F (93.33°C) sufficiently so that it can be bent as needed. It can be sawed, drilled and bonded, but not sheared. For best appearance, sawed edges should be buffed on material 1/8" (3.0mm) and thicker.
The base and cap materials were tested for flammability by Underwriters Laboratories. The base and cap materials are rated 94 HB on the UL 94 test.
 
NOTE: The above information is given in good faith, but no warranty, express or implied, is given.