Click to return to Home Page
  

rotary engravable >>
ADA Alternative
ColorCast Acrylics
ColorHues
NEW ColorHues™ EFX
FlexiBrass & FlexiColor
Fusion Grafix
General Purpose/Utility-Grade Sheet
Heavy Weights
Lacquers
LaserGlow
LaserLIGHTS
LaserMark
LaserMax
Lucent
Mattes
Message Board
Metalgraph plus
NoMark Plus
NEW Reflexions
Reverse LaserMark
Safe-T-Mark
Satins
Slickers
Standard Metals
Textures
The Naturals
UltraGrave
Ultra-Mattes Front-Engravable
Ultra-Mattes Reverse-Engravable

 


 
 Physical Properties
Typical Values ASTM Method
IZOD Impact Strength
Notched at 73°F (22.78°C) 2.5 ft lbs/in D-256
Tensile Strength
To break 5,400 psi D-638
Elongation before break 70% D-638
Flexural Strength
Load to stretch outer surface 5% 9,200 psi D-790
Specific Gravity 1.04 D-792
Rockwell Hardness R102 D-785
Deflection Temperature
Temperature at which material deflects .010" (.254mm) at 264 psi 175°F (79.44°C) D-648
Vicat Softening Point
Temperature for needle to penetrate 1mm (90°F/hr, 2.2 lbs) 225°F (107.22°C) D-1525
The physical properties of the VALUE SERIES MATTES engraving material are largely controlled by the base material. This material was chosen to provide a good balance of properties for this product to satisfy a wide range of uses.
The material softens at about 200°F (93.00°C) sufficiently so that it can be bent where needed. It can be drilled, sawed, sheared, nailed, bonded and die-cut.
The base material, as well as the foils, were tested for flammability by Underwriters Laboratories. The base material is rated as 94 HB on the UL 94 test. The foil was judged as not contributing to combustion of the base.
Most of the colors will exhibit slight fading under prolonged exposure to direct sunlight. There are, however, those which tend to fade more severely. This material is designed for use where no direct extreme exposure is encountered.
 
NOTE: The above information is given in good faith, but no warranty, express or implied, is given.