|
|
 |
|
Physical
Properties |
Typical Values |
ASTM Method |
| IZOD Impact Strength |
| Notched at 73°F (22.78°C) |
1.10 ft lbs/in |
D-256 |
| Tensile Strength |
| To break |
5,500 psi |
D-638 |
| Elongation before break |
50% |
D-638 |
| Flexural Strength |
| Loan to stretch outer surface 5% |
10,300 psi |
D-790 |
| Specific Gravity |
1.15 |
D-792 |
| Rockwell Hardness |
M45 |
D-785 |
| Deflection Temperature |
| Temperature at which material deflects .010" (.254mm)
at 264 psi |
175°F (79.44°C) |
D-648 |
| Coefficient of Thermal Expansion |
| Inch/inch/°F |
5.6 x 10-5 |
D-696 |
| Vicat Softening Point |
| Temperature for needle to penetrate 1mm
(90°F/hr, 2.2 lbs) |
208°F (97.78°C) |
D-1525 |
| Temperature for needle to penetrate 1mm (90°F/hr,
11.0 lbs) |
187°F (86.11°C) |
D-1525 |
|
| ADA Applique material softens sufficiently at about 200°F (93.33°C),
which enables bending, should that be desired. It can also be drilled,
sawed, sheared, nailed and bonded to itself or other materials. |
| Most of the colors will exhibit slight fading under prolonged
exposure to direct sunlight. There are, however, those which tend
to fade more severely. This material is designed for use where no
direct extreme exposure is encountered. (For exterior ADA
applications, see our Ultra-Matte line.) |
| The material was tested for flammability by Underwriters
Laboratories. It is rated at 94 HB on the UL 94 test. |
| NOTE: The above information is given in good faith, but no warranty,
express or implied, is given. |
|
|
|
|
|
