LaserLIGHTS adhesive information:
LaserLIGHTS are backed with a 1.5 mil (.0015"), acrylic pressure
sensitive adhesive designed for industrial applications. The adhesive
has excellent exterior properties and resistance to water, solvents and
extreme temperatures. It bonds extremely well to metals, plastics, rubbers
and foams. The adhesive has good initial tack, and fully sets up over
72 hours.Typical applications in which this adhesive is used include:
nameplates, electronics, appliances, recreational vehicles, computers,
packaging, aviation and automotive.
LaserLIGHTS Durability and Weatherability information:
LaserLIGHTS surface durability is about twelve times greater than that
of a conventional microsurfaced engraving plastic. On an RCA Taber
Abrader CS17 set at 500 gm, there was no wear through to the substrate after
a minimum of 70 cycles.
LaserLIGHTS and their adhesive withstand high temperatures, up to 250˚F
(121˚C) for intermittent and 200˚F (93˚C) for coninuous use. In specific
applications they have been successful at considerably higher temperatures.
|
